The year listed is the year of the award, for books published in the previous year. Each year the members of Mystery Readers International nominate and vote for their favorite mysteries in five categories. Eliot ( Old Possum’s Book of Practical Cats). You’ll need to have the smaller tool stick out slightly more than your 1/4” tooling.The Macavity Award is named for the “mystery cat” of T.S. The 1/4” tools that we stock typically have an overall length of 2”, whereas 1/8” tools typically have an overall length of 1.5.” Subsequently, most 1/8” tooling, when fully inserted into the collet––as we recommend for 1/4” tools-won’t reach the top of the bed to perform a successful tool touch-off if it’s inserted 3/4” into the collet. It’s important to note that some tools are longer than others, and tools can be inserted into the collet at different depths. Remember, don’t fully tighten the nut without a tool inserted. Screw the collet and collet nut back onto the tool holder with two or three turns, or use the wrenches, if necessary.Insert the new ER-11 collet into the collet nut-you’ll hear it snap into place. Remove the ER-11 collet from the collet nut.Use the smaller wrench on the flat part of the tool holder to secure it in place, and then use the larger wrench to unscrew the nut. Remove the collet nut from the bottom of the tool holder.To ensure accuracy and compatibility, we recommend using the ER-11 collet in our store. However, if you’re going to use smaller tooling, you’ll need to use a collet that supports smaller tooling. The collet that comes with your Bantam Tools Desktop CNC Milling Machine supports 1/4” tooling. If possible, use your finger to hold onto the tool while loosening so that it doesn’t fall from the collet. To remove a tool : Use the smaller collet wrench to hold the spindle in place while loosening the collet nut with the larger collet wrench. Once you’ve attached your material to the bed, set your material dimensions, and loaded a plan into the software, you can begin milling. You’re done! The tool is installed and the software has located the tip of the tool in space. Note: Alternatively, you can navigate to the Jog tab and click the install Tool button to launch this probing routine. Confirm that nothing is blocking the tool, and then click Start. Click Next, and the spindle will move to the default tool touch-off location at the front right corner of the bed.Then use the collet wrenches that come with the machine to tighten the tool until it’s snug, but be careful not to over tighten it.Use your fingers to tighten the collet nut with the tool inserted. Slide the tool (with 1/4” shank) into the collet all the way until it stops.If there is a tool already installed from a previous job, remove it. Loosen the collet nut about halfway using the collet wrenches or your hands. The spindle will move to the center of the Bantam Tools Desktop CNC Milling Machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |